Flowserve ISC2SS Uživatelský manuál Strana 1

Repair InstructionsISCFlow Solutions DivisionISC2SSDual Stationary Bellows Seal

10 2 Trademark of Minnesota Mining and Manufacturing Company4.17 Using firm hand pressurepress down on the collar tobe even with the end of thesleeve

Figure 22O-ring11Gland GasketG115 Static Testing5.1 Flowserve manufacturing typically tests the ISC at 25 psig. A pressure dropof less than one psi ov

TO REORDER REFER TOB/M #F.O.FIS141ORG 06/00 USAFlowserve Corporation Flow Solutions DivisionPrinted in U.S.A.ISO 9000CertifiedGermanyBrazilMexicoKalam

2© Copyright 2000 Flowserve Corporation1 NomenclatureNotes: - Inboard bellows assembly (34A) is interchangeable with outboard bellows assembly (34).-

2 Disassembly33 Inspection and Reconditioning3.2 Gland Assembly 1 (Figure 2)Figure 21 Registered Trademark of Loctite CorporationWhen disassemblin

43.4 Inner Gland 1C (Figure 4)A Mating ring O-ring surface - Inspectfor wear, fretting, nicks, scratches,or corrosion. Required surfacefinish: 63

SL on a flat surface with thecollar end facing up. Installthe inboard vibration dampener M1 into the sleeve end housing.Place the inboard bellows O

4.5 Align the two flats on theinboard mating ring 3C withthe two flats on the inside ofthe drive ring 10A in thesleeve end housing, andpress the m

74.8 Place the inner gland/bellowsassembly face down onto thesleeve/mating ring assembly.(Figure 11)4.9 Install the inner gland O-ring G1 into the fa

4.12 Insert the retaining ring RRinto the groove in the sleeveassembly while pressingdown on the rotor carrier.Make sure that the retainingring snaps

9Figure 174.15 Place the gland/bellowsassembly face down onto thesleeve/outboard mating ringassembly. (Figure 19)Figure 184.15 Assemble the outboardbe