Flowserve CBR Series Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Flowserve CBR Series. Flowserve CBR Series User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Installation
Instructions
CBR Series
Single Inside Bellows Seal
Experience In Motion
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Instructions

Installation InstructionsCBR SeriesSingle Inside Bellows SealExperience In Motion

Strany 2 - 1 Equipment Check

21 Equipment Check1.1 Follow plant safety regulations prior to equipment disassembly: • lock out motor and valves.

Strany 3 - 2 Installation

31.7 Check gland pilot and bolt holes to ensure they are adaptable to the equipment and are the same as shown on the assembly drawing.1.8 Handle all

Strany 4

4Determining the Correct Installed Operating Length Dimension Figure 3Inch Units(Metric Units)R(I1) 18

Strany 5

52.2 Scribe mark B, Figure 1, at the seal setting point shown on the assembly drawing included with the seal. (This is the seal setting dimension as

Strany 6 - 3 Vertical Pumps

62.12 Position the gland to the face of the seal housing. Be sure the gland pilot is properly engaged. Tighten the gland stud nuts evenly, cross s

Strany 7 - 5 Repair

75 RepairThis product is a precision sealing device. The design and dimension tolerances are critical to seal performance. Only parts supplied by Flo

Strany 8 - TO REORDER REFER TO

flowserve.comTO REORDER REFER TOB/M #F.O.To nd your local Flowserve representativeand nd out more about Flowserve Corporation, visit www.owserve.co

Komentáře k této Příručce

Žádné komentáře