Flowserve ISC2 Single Pusher Repair Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Flowserve ISC2 Single Pusher Repair. Flowserve ISC2 Single Pusher Repair User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Repair
Instructions
Experience In Motion
ISC2
Single pusher seal
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Instructions

RepairInstructionsExperience In MotionISC2Single pusher seal

Strany 2 - 3 Repair or Replace Guide

ISC2-PX1.875316 SS2 DisassemblyWhen disassembling the seal, inspect for conditions which may have caused the seal to be removed from service. If seal

Strany 3

3 Seal parts that are reconditionable • Gland assembly [11] • Sleeve assembly [1] • Sleeve collar [58] 4 Inspection and

Strany 4 - 6 Seal Assembly Instructions

45 Seal Assembly PreparationTools Needed:• Sizes ≤ 2.750": 3/16", 1/8" hex key wrenches • Sizes > 2.750": 1/8", 3/16&q

Strany 5

5 For sizes ≤ 2.750 inch (70 mm) install the vibration damper [183] into the back counterbore of the sleeve assembly. For sizes > 2.750 inch (70

Strany 6

66.8 Select O-ring [13]. Lightly lubricate the O-ring using silicone grease. Install the O-ring onto the stationary face [14]. See Figure 11.Figure 1

Strany 7

7 6.17 Perform a dry t of the collar on the sleeve.6.18 Install the drive collar [58] onto the sleeve assembly [1]. The drive collar may need to be

Strany 8 - 8 Installation

TO REORDER REFER TOB/M #F.O.FIS191eng REV 09/14 Printed in USAflowserve.comTo find your local Flowserve representativeand find out more about Flowserve C

Komentáře k této Příručce

Žádné komentáře