Flowserve ISC1BX Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Flowserve ISC1BX. Flowserve ISC1BX User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Repair Instructions
ISC
Flow Solutions Division
ISC1BX
Single Rotating Bellows Seal
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Repair Instructions

Repair InstructionsISCFlow Solutions DivisionISC1BXSingle Rotating Bellows Seal

Strany 2 - 1 Nomenclature

2 DisassemblyWhen disassembling seal, inspect for conditions which may have caused theneed for the seal to be removed from service. If seal was remove

Strany 3 - Required surface

A Mating ring O-ring surface - Inspect for wear, fretting, nicks,scratches, or corrosion. Required surface finish: 63 RMSB Gasket surface - Remove the

Strany 4 - 4 Seal Assembly Instructions

44 Seal Assembly Instructions4.1 Tools Required•3/32", 1/8" hex key wrenches (Sizes < 2.625"); 1/8", 3/16" hex keywrenches

Strany 5

54.6 Place the mating ring O-ring P in the gland assemblybehind the gland drive ring 1B . Place the vibrationdampener M into the grooveat the front

Strany 6 - Be careful not to

64.9 Place the sleeve collar 9onto the end of the sleevewith the "Flowserve" logofacing up. Align the quarterdog set screws with thesmaller

Strany 7 - 6 Installation

75 Static Testing5.1 Flowserve manufacturing typically air tests the ISC at 25 psig. A pressure dropof less than one pound at 25 psig is acceptable. T

Strany 8 - TO REORDER REFER TO

TO REORDER REFER TOB/M #F.O.FIS138ORG 06/00 USAFlowserve Corporation Flow Solutions DivisionPrinted in U.S.A.ISO 9000CertifiedGermanyBrazilMexicoKalam

Příbuzné modely ISC1SX

Komentáře k této Příručce

Žádné komentáře