Flowserve SLM-6000 Uživatelský manuál stáhnout pdf (Strana 3)

2.2 The saddle ts of the bearing assembly should not be worn.

2.3 The axial end oat of the pump shaft must not exceed 0.25 mm (0.010"). See Figure 2.

2.4 Shaft radial runout should be less than 0.0005 mm per mm (0.0005" per inch) of

shaft/sleeve diameter. See Figure 3. Turn the shaft through 360° and observe the

range of indicator movement.

Check Radial Shaft Runout Figure 3

Check Axial Shaft Travel Figure 2

Maximum Acceptable Radial

Run Out 0.0005 mm per mm

(0.0005" per inch) of shaft

diameter

0.25 mm (0.010") Maximum

Acceptable Axial Movement

2.5 The shaft should deect no more than 0.30 mm (0.012") at the seal chamber face.

See Figure 4.

Shaft should Deect no more

than 0.30 mm (0.012")

Check Radial Shaft Deection Figure 4

1 2 3 4 5 6 7 8 ... 11 12

Žádné komentáře

Flowserve SLM-6000 Uživatelský manuál Strana 3