Flowserve PSS II Durametallic Uživatelský manuál stáhnout pdf

Experience In Motion

Installation

Instructions

Durametallic

PSS II

Split Seal

1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Instructions

Experience In MotionInstallation InstructionsDurametallic® PSS IISplit Seal

Strany 2

While the PSS II has been designed for rugged industrial application and ease of installation, it does require assembly in a clean environment accor

Strany 3 - Tools Needed for Installation

3Tools Needed for Installation •5/32", 5/16" and 3/32" or 1/8" T-handle hex key wrenches (supplied with seal) • Anopenendwr

Strany 4

4Step 4a With the setting devices against the box face, tighten the set screws. Seal sizes up to 101.6 mm (4.000 inch) have four set screws all at

Strany 5

5Step 7 Observe the length of the lock pin outside of the gland. The pin should extend 2.5 to 4.8 mm (0.10 inch to 0.19 inch) from the gl

Strany 6 - Operational Recommendations

6Notes for Figure 3: • Recommendationsareforuseinwaterorothersimilarviscosityliquids. • Theserecommendationsapplytoproductshavinga

Strany 7

7RepairsThis product is a precision sealing device. The design and dimension tolerancesarecriticaltosealperformance.OnlypartssuppliedbyFlows

Strany 8 - ﬂowserve.com

TOREORDERREFERTOB/M #F.O.FIS145eng REV 5/13 Printed in USAFlowserve Corporation has established industry leadership in the design and manufacture o

Komentáře k této Příručce

Žádné komentáře

Flowserve PSS II Durametallic Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Flowserve PSS II Durametallic. Flowserve PSS II Durametallic User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Hardware Flowserve PSS II Durametallic