Flowserve ST Series Uživatelský manuál stáhnout pdf (Strana 5)

Centering and Attachment Screws Figure 3

Itisessentialthatbeforetighteningboltsthemotor/gearbox/seal

assembly center of mass be found and that point used to lift the

sealhousingsintoposition.Theboltingtothemixerangeshould

becompletebeforethesupportforthemotor/gearbox/sealis

removed.

2.1.3 Lower the shaft through the seal cartridge. Great care must be

taken to avoid any binding that may cause the seal hardware to

support the shaft.

2.1.4 When the shaft has threaded through the seal attach the shaft

as required to the mixer drive. Takecaretoinsurethattheshaft

isstraightandconcentricwiththeboreofthemixerange.Follow

mixer drive manufacturer re dations.

2.1.5 After the shaft is in its nal operating position and no more

adjustmentswillbemadetothepositionoftheshaft,doublecheck

thesealcanisterandtightencanisterboltingtothemixerange

and/ormixerdrive. 

2.1.6 Attach the rotating portion of the seal to the shaft. Thesealyou

areinstallingisdesignedtotyourspecicpieceofequipment.

Withthisinmindrefertothedrawingspecictothissealandyour

equipment. Note that there may be small differences from this

instruction in how this step is accomplished. See Figure 3.

5 7.1

57.2

1 2 3 4 5 6 7 8

Žádné komentáře

Flowserve ST Series Uživatelský manuál Strana 5